These are the instructions that come with every Flag Caddie ordered

Remove roof panels or lower the convertible top. See year and model for installation of Flag Caddie.

Screw Flag Caddie into 1/4 - 20 rear roof tie down.

Insert bolt from bottom side of windshield guide pin opening, then screw on Flag Caddie.

2005 & UP Convertible Front Mount

Minor modification required on C6 convertibles (see C6 page) necessary for high speed use only!

84-86 and 87-96 Coupe Front Mount

Insert No. 40 TORX wrench (Supplied with car) from bottom side of roof mounting bolt, push bolt up then tighten Flag Caddie onto bolt. (Caution: Do not over tighten)

Screw latching bolt into Flag Caddie 2 turns.
Align groove with rear latch rod and push down until it latches then lift and tighten Flag Caddie.

Note: When releasing, unscrew Flag Caddie 1/2 turn, hold Flag Caddie, then pull latch release lever

86-96 Convertible Front Mount

Screw latching bolt into Flag Caddie 8 full turns. Align notches in latch bolt with windshield roof latch mounting pins, then insert and tighten Flag Caddie.

Note: When releasing, unscrew Flag Caddie 1/4 turn, then lift.

Insert thumb screw from bottom of windshield roof guide pinhole, then screw on Flag Caddie until tight.

Screw latching bolt into Flag Caddie 2 turns.
Align groove with rear latch rod and push down until it latches then lift and tighten Flag Caddie.

Note: When releasing, unscrew Flag Caddie 1/2 turn, hold Flag Caddie, then pull latch release lever